"DB3" Rear Control Arm Correction Bracket

Metalcloak

Supporting Vendor
Please click the link below to view instructions (.pdf) referenced in the title of this thread.

JK "DB3" Rear Control Arm Correction Bracket

JK "DB3" Rear Control Arm Correction Bracket Installation Video

Please assist us in our commitment to continuously improve our installation instructions. If you think information is missing, have advice to share with others, or have clearer pictures/illustrations please post them to this thread. All feedback is greatly appreciated!

Only One Rule...Please Be Cool.

If you notice a post that has been deleted, we likely implemented the idea into our published instructions.

Questions about your installation?
Please email [email protected] or call 916-631-8071

The comments in this forum do not represent official advice from MetalCloak. Users of MetalCloak products follow the advice of others at their own risk.
 
Last edited:

Alfredo

Jeep Newb
This morning I fiddled with the spring alignment correction retainer and shortened the upper control arm by 3/8” it looks a little better. Should I shorthorn them all the way? I have 4.5” true dual rate springs. The first pic is axle slight droop (frame on stands no tires slight support by floor jack.) test of pics are tires on, wheel and full weight on the ground.
 

Attachments

Top