So my overline fenders finally came in and I couldn’t wait to see what the narrow flares looked like on the fenders. So I got all the bubble wrap off both of them and placed the flare on the fender and they didn’t fit! The holes that they bolt together at fit perfect at the base. But at the front end the flare sat about an inch higher.
Well after I calmed down and made a quick phone call. I found out this IS BY DESIGN. They do this to creat strength in the fender.
What you have to do is bolt the bottom of the flare on but do not tighten all the way. Then put a small amount of pressure on the front of the flare so that it lines up with the “ball” and bolt it on.
After all of that it fit like a champ and was very solid. I will be installing these on Sunday and will post up pictures and video better explaining the process. ��
Sent from my iPhone using Tapatalk
Well after I calmed down and made a quick phone call. I found out this IS BY DESIGN. They do this to creat strength in the fender.
What you have to do is bolt the bottom of the flare on but do not tighten all the way. Then put a small amount of pressure on the front of the flare so that it lines up with the “ball” and bolt it on.
After all of that it fit like a champ and was very solid. I will be installing these on Sunday and will post up pictures and video better explaining the process. ��
Sent from my iPhone using Tapatalk
Last edited: